Mallinckrodt NPB-190 Manuel de l'opérateur télécharger pdf (Page 52)

Start-Up and Use

Since the monitor cannot operate with a fully discharged battery,

before attempting to turn on an NPB-295 whose battery charge

has been depleted, first plug the monitor into an AC outlet to

allow the battery to charge for a few minutes. The monitor may

then be powered on.

To charge a dead battery, connect the monitor to AC power. A

full charge takes 14 hours while turned off, or 18 hours during

regular use.

When all of the following conditions are present for 15 minutes,

the NPB-295 will automatically shutdown:

• Running on battery power

• No buttons have been pressed

• No pulse has been detected (for example, when no patient is

connected to the sensor or the sensor is disconnected)

• No alarms are present (other than low battery or a non-

correctable error)

Low Battery Indicator

The Low Battery Indicator lights and a low priority alarm begins

to sound when approximately 15 minutes of monitoring time is

available on the existing battery charge. This alarm cannot be

silenced while running on battery power. Connect to AC power

to silence the alarm.

Note: If the AC voltage selector switch on the rear panel does

not match your AC voltage source, the monitor may run

on battery power, even though it is plugged in, which will

eventually result in a low priority alarm and a lighted low

battery indicator. Ensure the switch setting matches your

AC voltage source.

If the monitor is not connected to AC power within

approximately 15 minutes, it will shut down.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 86 87

Pas de commentaire

Mallinckrodt NPB-190 Manuel de l'opérateur Page 52